Selection of electric push rod Requirements to be met by power tube

For many users' friends, it is very important for practical production to choose an electric putter with suitable model and excellent performance. What points do we need to consider when choosing the type?

1. In the process of design and production of electric push rod, manufacturers usually make customized processing according to the actual requirements of users. Therefore, it often takes some time to supply in this process. Therefore, during the selection period, we need to determine the time limit in advance to ensure that it will not affect the use.

2. Because the product belongs to auxiliary equipment, that is, it needs to cooperate with other equipment, so the specific size must also be considered in advance.

3. During the selection of electric push rod, the actual functional requirements of electric push rod products should also be clear. This is also to ensure the accuracy of production as much as possible, so as not to cause trouble in the later stage. Of course, we should also pay attention to the selected materials, production technology and production quality standards.

Also pay attention to the actual application frequency of electric push rod. This is because, according to the use situation, the requirements of its action frequency are different. In order to ensure the practical application results, this must also be taken into account. Also pay attention to its grade. According to its rated thrust, it can be divided into 12 levels.

For the whole electric putter, the power tube is an appropriate and important part. Of course, its skill requirements are stricter than those of the electric putter, especially its accuracy. In this case, what conditions does the electric push rod product put forward about the power tube?

During the experiment, the roughness of several electric push rod shaft parts was measured in different directions, and it was found that the measuring system was excellent and the process was controlled. In the process of further analysis, it is found that the process ability is lacking when analyzing the process ability, and it is necessary to improve the production technology and improve the production ability.

Further analysis shows that the power tube of electric push rod not only meets the accuracy requirements of the scale surface, but more importantly, it must ensure that the appearance roughness of the 35-diameter part of the scale in the center of the power tube reaches 0.4um, which is almost impossible in practical machining operations.

Due to the limitations of the original production technology, the choice of processing method is to use lathe to drive parts to roll, which not only needs more time, but also wastes a lot of materials and energy. Together, after treatment by this method, the roughness of the power tube parts of the electric push rod is different.

Because of this, the effect of post-treatment process will be affected, resulting in a decrease in wear resistance. In this case, the cooperation gap between the power tube and the flange screw of the electric push rod can be properly adjusted, which can not only reduce the unqualified products, but also improve the production capacity of the electric push rod.