What devices does the electric push rod mainly include?

The technical parameters of electric push rod include the concepts of full load and no load, in which full load speed refers to the speed that the push rod can reach under its rated load, and its unit is usually mm/s. There is an inverse relationship between full load speed and load, so it is usually impossible to combine high speed and high load. However, if the installation distance is treated, this contradiction can not be alleviated to some extent. In addition, full load speed and no load speed form the speed range of push rod.

Because the no-load speed of electric push rod refers to the speed at which the push rod moves without any load, and the unit is usually mm/s, the important function of the no-load speed is to indicate the speed limit of the push rod to match the full-load speed and clarify the speed range of the push rod. For electric push rod, the safe use of the control valve will directly affect its working effect. It is precisely because of this importance that the control valve in the electric push rod must be strengthened and its failure rate reduced to ensure that the electric push rod can obtain ideal use effect.

At present, the control valve of electric push rod mainly includes a variety of high-pressure safety valves, low-pressure safety valves and high-and low-pressure check valves. In addition, there is an ultra-high-pressure manual directional valve with a multi-position four-way directional valve at the top. The key is that it avoids affecting its heat transfer performance. Reasonable structural design makes the maintenance of electric push rod very convenient, and it also has good pressure retention ability to ensure the safety of electric push rod. When the valve in electric push rod is loaded, the first thing to consider is its model, which must be used as the basis of operation.

Due to the extension operation of the electric push rod, it has a certain pushing effect on the driving rod. Under the action of the driver, the frame is driven to perform forward work, and then the material above the adhesive tape is put into the hopper and then transported to the designated position. When the unloading operation is completed, the electric push rod is retracted again, and the driving rod is also driven to complete the corresponding work.